Home › Access Control

120HWCP20M

120 HWCP 20M - 120 Volt AC 3-Wire - 15-20 Amp (Series)

120 HWCP 20M: If your power side
of the system requires a hardwire connection, this 120 Volt AC 3-Wire
Single Phase (15-20 Amp) device should be installed as close as
possible to the equipment being protected. This
is an in-line series (AC) surge suppressor and is designed to stop
surges from getting to the PLC – (Mother Board/Computer Board). The 120HWCP20M has a maximum current draw of 15-20 amps and provides both common and normal three-phase noise filtration. UL 1449 listed and rated 400V peak for L-N, L-G, N-G.

Specifications – Operating:

Maximum Operating Voltage:

120 Volts AC

Typical Leakage Current:

None

Operation Temperature:

- 40 to + 85° C

Connection:

Hardwired

Lines Protected:

L/N, L/G, N/G

Installation Configuration:

In-Line Series

Specifications – Electronic:

Maximum Surge Current (8x20µs):

6,000 Amps Total

Maximum Surge Voltage (1.2x50µs):

3,000 Volts

Clamping Voltage: 

130 Volts RMS

Clamping Response Time:

<5 nanoseconds

Maximum Line Voltage:

15-20 Amps @ 120 VAC 45/60 Hz

Voltage: 

Voltage Sensitive

Operation Indicator:

Yes - LED

Power Dissipation (8x20µs): 

750 Joules or (20,000,000 VA)

UL Recognized Component:

TVSS Device UL File E121637

Failure Mode:

Fails Safe (Open)

Dimensions:

Depth: 1.5” Width 3” Length 5” Tabs .5”

Weight:  

Approximately 1 Lb.

E-Clips surge suppressors have a Lifetime Product Warranty. Please see warranty statement for complete product warranty information.